ISO/TR TECHNICAL REPORT 18130 First edition 2016-05-01 Dentistry Screw loosening test using cyclic torsional loading for implant body/implant abutment connection of endosseous dental implants Medecine bucco-dentaire - Essai de dévissage d'une vis utilisant une charge de torsion cyclique pour le corps d'implant/pilier implantaire des implants dentaires endo-osseux Reference number X ISO/TR 18130:2016(E) ISO International Organization for Standardization =ZHEJIANG INST OF STANDARDIZATION C1 5956617 @IS02016 mitted without license from IHS IS0/TR 18130:2016(E) COPYRIGHTPROTECTEDDOCUMENT IS0 2016, Published in Switzerland All rights reserved. Unless otherwise specified, no part of this publication may be reproduced or utilized otherwise in any form or by any means, electronic or mechanical, including photocopying, or posting on the internet or an intranet, without prior written permission. Permission can be requested from either ISO at the address below or ISO's member body in the country of the requester. ISOcopyrightoffice Ch. de Blandonnet 8 · CP 401 CH-1214 Vernier, Geneva, Switzerland Tel. +41 22 749 01 11 Fax +41 22 749 09 47 [email protected] www.iso.org Internationai ibrg DrganizationforStandardization nsee-ZHEJIANG INSTOF STANDARDIZoISQ6- All rights reserved Not for Resale, 2016/7/20 08:19:27 networking permited withoutlicense from IHS IS0/TR 18130:2016(E) Contents Page Foreword ..iv Introduction. ..V 1 Scope. 2 Normative references 3 Terms and definitions 4 General principle ..2 5 Test methods. 2 5.1 Test condition. 2 5.2 Torque meter 2 5.3 Preparation of test specimens. .2 5.4 Initial screw removal torque. .3 5.4.1Procedure.. 3 5.5 Screw removal torque after cyclic torque test .3 5.5.1 Cyclic torque tester. 3 5.5.2 Torque transducer ..4 5.5.3 Procedure. .4 5.6 Evaluation. ..5 6 Test report ..5 Bibliography .6 ii icensee=ZHEJIANG INST OF STANDARDIZATION C1 5956617 vided by IHS under I se with ISt ed without license from IHS Not for Resale, 2016/7/20 08:19:27