ISO INTERNATIONAL STANDARD 9455-2 First edition 1993-04-15 Soft soldering fluxes --. Test methods Part 2: Determination of non-volatile matter, ebulliometric method Flux de brasage tendre-Méthodes d'essai- Partie 2: Dosage des matieres non volatiles par ébulliométrie Referencenumber ISO9455-2:1993(E) Copyright Intermational Organization for Standardization rovided by IHS rmitted without license from IHS Not for Resale ISO9455-2:1993(E) Foreword ISO (the International Organization for Standardization) is a worldwide of preparing International Standards is normally carried out through ISO which a technical committee has been established has the right to be represented on that committee. International organizations, governmenta and non-governmental, in liaison with ISO, also take part in the work. IsO collaborates closely with the International Electrotechnical Commission (IEC) on all matters of electrotechnical standardization. DraftInternational Standardsadoptedbythe technical committees are circulated to the member bodies for voting. Publication as an International a vote. International Standard ISO 9455-2 was prepared by Technical Committee ISO/TC 44, Welding and allied processes, Sub-Committee SC Soldering and brazing materials. IsO 9455 consists of the following parts, under the general title Soft soldering fluxes - Test methods: Part 1: Determination of non-volatile matter, gravimetric method -Part2:Determinationofnon-volatilematter,ebulliometricmethod Part 3: Determination of acid value, potentiometric and visual titration methods -Part5:Coppermirror test - Part 6: Determination of halide content - Part 8: Determination of zinc content -Part9:Determinationof ammonia content Part 10: Flux efficacy tests, solder spread method -Part11:Solubilityoffluxresidues ISO1993 All rights reserved. No part of this publication may be reproduced or utilized in any form or by any means, electronic or mechanical, including photocopying and microfilm, without per- mission in writing from the publisher. International Organization for Standardization Case Postale 56 CH-1211 Geneve 20· Switzerland Printed in Switzerland := Noreproductionor networking permited without licensefrom IHS Not for Resale ISO 9455-2:1993(E) Part 12: Steel tube corrosion test Part 13: Determination of flux spattering 一 Part 14: Assessment of tackiness of flux residues - Part 15: Copper corrosion test 一 Part 16: Flux efficacy tests, wetting balance method [Technical Report] - Part 17: Determination of surface insulation resistance of flux resi- dues (Comb test) - Part 18: Electrochemical migration test for flux residues Annex A of this part of ISO 9455 is for information only ili Copyright International Organization for Standardization No reproductio n or networking permitted without license from IHS Not for Resale